Fibaro Z Wave Universal Sensor

$79.20

Out of stock

SKU: DHS-SNS-UN-FIB Categories: ,

The Fibaro Z-Wave Universal Sensor is a wireless module that makes it possible to improve the functionality of any sensor with a binary output by allowing it to communicate with the wireless Z-Wave network and the Z-Wave Gateway. Moreover, the module allows for wireless communication between the system and the DS18B20 temperature sensors. The device can service up to two binary sensors and up to four DS18B20 temperature sensors.

The Fibaro Z-Wave Universal Sensor may be used whenever wireless collection of data from wired sensors is required. Once additional safety housing have been installed, the device can also be used in areas with high humidity and high temperature.

The Fibaro Z-Wave Universal Sensor’s main function is the integration of the wireless Z-Wave System with the existing wire-based and wireless alarm and measurement systems.

This product integrates with all Australian certified (921.42MHz) Z-Wave controllers including:

 

  • Vera Edge/VeraPlus
  • Fibaro Home Controller 2/Lite
  • DHS Z-Wave Universal Remote Controller

Please check the maximum load before installing/operating.
This installation must be done by a certified electrician in Australia and New Zealand.
Before engaging an electrician, check that they provide an electrical compliance certificate.
For warranty claim you have to provide an installation compliance certificate from your electrician.

 

Please note:

In Vera it does not display any change to the devices state no matter how you connect after initial inclusion, however its can be easily resolved you just need to follow the steps below:

In order for the inputs to work properly after you have included the device you need to add a variable to each of the inputs, To do this you need to go to devices, press on the arrow to the right of the device on each of the devices to into Advanced > New Service and add the variable information below;

Service: urn:micasaverde-com:serviceId:ZWaveDevice1
Variable: BasicSetCapabilities
Value: 00=U0,FF=T0

Copy and paste in the codes as well so you dont need to type them in, after that press add, once the little prompt has disappeared press reload engine, give it a minute or so and the device should work as intended.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.